Applied or new outboard motors will need no call for typical care right after each use. Outboard motors are not like automobile engines in the sense that they are going to need to have additional upkeep than just every 3000 miles. Outboard motors have to deal with a lot a lot more environmental elements than a typical car engine. Point of reality, car engines never have to deal with salt deposits left from salt water use. Now do they have to worry about constant water intrusions that outboard motors deal with for the duration of every single use. So, it is no wonder that outboard motors will require upkeep soon after each and every use.

Actions that need to take spot following just about every trip with a Outboard motor:

1. Flush the engine – This does not apply to just salt water outings, fresh water can do just as substantially damage as salt water.

* Purchase a pair of rabbit ears. This is a versatile rubber seal connected to a metal clamp. This unit is support flush the engine. connect the unit on the reduce element of the motor have been the water is picked up. Connect a water hose to the back of the rabbit ears.


2. Start off the engine and let the water pump to its perform. The water pump will pull in the clean water and wash away any left more than salt or sentiment that may well have constructed up through your adventure.

three. Even though flushing the motor verify the water pump to see if your obtaining a good water flow. Carefully, place your hand in the stream of water. If the water is not pumping challenging then you could have a block once more the outflow tube. If so quit the engine quickly and clear the debris. You can do this by sticking a small wire into the flow tube and operating it back and forth. Immediately after you believe the tube is cleared re-start off the engine and verify the flow once more.

4. When the flushing of the engine is complete discount the gas line and let the engine to run off the excess fuel in the . Just after excess fuel is burnt off place the fuel line back in spot.

5. Next verify for old and water leaks. This is carried out by taking the cowling off. If you come across a link consult a boating mechanic to have the concern fixed.

six. As soon as you have cleaned and checked every thing it is time to wipe every thing down and spray with a anti-corrosive like WD40 or Rapid-lube.

7. Replace mercury 2.5 outboard and place a plastic cover on the engine to stop anything from obtaining in on your engine.